ArmSoM
← All stories

Creating a Portable Linux Device: Power and Enclosure Planning

A portable Linux system needs a power design for the whole assembly: board, display, storage and peripherals. Battery capacity alone does not establish runtime. Measure the intended workload and account for the conversion and shutdown behavior.

ArmSoM Sige7s

ArmSoM Sige7s

Measure at the battery-side boundary

Record the battery, regulator and output arrangement, then measure representative startup and operating loads. Include peripherals and wireless activity. Check the board’s required input range against the regulator’s behavior as the battery discharges. Test low-power handling with expendable data before relying on it in a portable product.

Design shutdown and charging together

Define how low battery is detected and how Linux stops safely before power disappears. Verify behavior while charging and under load, including cable changes. Do not improvise battery charging from GPIO or an unverified power path. Use documented modules and qualified review for the battery subsystem.

Test the actual enclosure

Cooling, connector access, antenna placement and mechanical mounting affect a portable product. Run the intended workload continuously and measure temperature and energy use. Check sleep or standby only where the selected image supports the needed behavior. Publish runtime for a named battery and workload rather than deriving a marketing figure from nominal capacity.

ArmSoM Sige1

ArmSoM Sige1

Match the choice to your requirements

Requirement or situation

What to evaluate

Decision detail

Demand

Boot, steady load and peripherals

Measure energy over the duty cycle.

Power system

Charging, protection and shutdown

Use a documented design.

Enclosure

Cooling, antennas and access

Test the assembled device.

Example design

A battery budget includes converters and peripherals

For a portable Linux system, measure input power at the battery or supply boundary as well as at the board if possible. Conversion losses, displays, storage and radios can change the result substantially. Test low-battery shutdown and recovery after charging. Battery capacity divided by an idle board figure is not a reliable runtime estimate for an active product.

Hardware and documentation

Sige1 · RK3528

RK3528 single-board computer. Use the Sige1 hardware guide and matching image for setup.

Hardware documentation · Product details

Sige7s · RK3588S

RK3588S, 6 TOPS NPU, Gigabit Ethernet and removable eMMC. Dimensions: 85 × 56 × 17 mm. Disconnect power before replacing eMMC.

Hardware documentation · Product details

Frequently asked questions

Can I estimate runtime from board idle power alone?

No. Use the complete device workload and the usable energy delivered by its power system.

Product information and support

Explore Sige1

Contact ArmSoM

Sources

Written by ArmSoM using the documentation below. Example designs are proposals, not measured customer installations.

Related reading