ArmSoM
← All stories

Power-Loss Recovery for an SBC NAS: What Your Test Plan Should Cover

A NAS should be able to recover from an interrupted write without relying on a lucky reboot. Test the power and filesystem behavior with expendable data before trusting it with backups. A UPS also needs a working shutdown and restart procedure.

ArmSoM Sige7

ArmSoM Sige7

Define what must survive an interruption

Separate recoverable media from configuration, databases and other critical state. Use a disposable dataset when testing failures, and verify the restored contents afterward. Record how the application flushes data and how the system responds to a low-power signal. Power-loss testing should cover the assembled storage system, including bridges and external supplies.

Test shutdown as a complete sequence

For a Sige7 NAS, observe how low backup energy is detected, how services stop and when storage is unmounted. Confirm that power remains available long enough for the sequence. Test power returning during shutdown and repeated short interruptions. A battery capacity label alone cannot establish useful hold-up time for a loaded system.

Check recovery and integrity

After restart, verify files against checksums and inspect service state. Record whether interrupted transfers resume or are rejected clearly. Test backup restoration separately from filesystem recovery. Document the exact power module and load; results from one drive configuration should not be generalized to a different array.

Match the choice to your requirements

Requirement or situation

What to evaluate

Decision detail

Preparation

Disposable data and backup

Avoid destructive testing on valuable files.

Interruption

Defined loads and timing

Observe shutdown behavior.

Recovery

Integrity checks and service state

Confirm an actual usable system.

Example design

Protect the data, not only the power rail

A backup supply should give the system enough time to stop new work, flush application state and shut down correctly. Test that sequence with active writes and check the restored data afterward. Cutting power after an arbitrary delay does not prove that a database or filesystem is consistent. Include the case where the backup supply is already partly depleted when a second interruption occurs.

Hardware and documentation

Sige7 · RK3588

RK3588, 6 TOPS NPU, dual 2.5GbE and M.2 PCIe 3.0 x4. Check the selected eMMC and wireless configuration.

Hardware documentation · Product details

Frequently asked questions

Does a UPS guarantee no corrupted data?

No. Storage behavior, shutdown integration and the application’s write strategy still matter.

Product information and support

Explore Sige7

Contact ArmSoM

Sources

Written by ArmSoM using the documentation below. Example designs are proposals, not measured customer installations.

Related reading