ArmSoM
← All stories

Dual-Ethernet ARM SBCs for Routing: What to Measure Before Deployment

A two-port SBC can act as a router, bridge or application gateway. Those roles use the hardware differently and have different isolation requirements. Decide which one is needed before interpreting a network benchmark or configuring the interfaces.

ArmSoM Sige3

ArmSoM Sige3

Define the forwarding behavior

Draw the trusted and untrusted networks, management access and permitted traffic. State whether packets are bridged, routed, filtered or handled by an application. Test the intended rules and encryption together with representative traffic. A direct file transfer is not a measurement of the same board acting as a configured router.

Test paths separately

Measure each port and then the complete forwarding path. Use capable peer machines so the test endpoints do not set the ceiling. Add the intended firewall and VPN configuration before the final measurement. Observe CPU use, packet loss and temperature during sustained traffic, including many small packets.

Plan failure behavior

Confirm which services start after a power interruption and whether the device fails into an acceptable state. Keep an out-of-band management or local recovery method. Save network configuration and credentials securely. A fast laboratory result does not establish that the gateway can be safely maintained in an unattended deployment.

ArmSoM Sige7

ArmSoM Sige7

Match the choice to your requirements

Requirement or situation

What to evaluate

Decision detail

Traffic

Packet size and concurrent flows

Match the real workload.

Features

Firewall and VPN enabled

Measure the shipped configuration.

Recovery

Reboot and management access

Avoid lockout during updates.

Example design

Measure the traffic your gateway will handle

Large unencrypted packets, many short connections and encrypted tunnels place different demands on a gateway. Select the intended forwarding rules and application services before testing. Exercise both directions and simultaneous traffic if the deployment requires it. A two-port board’s physical link rates do not specify its routing, filtering or encryption performance. Capture CPU load and loss or retransmission information alongside useful throughput.

Hardware and documentation

Sige7 · RK3588

RK3588, 6 TOPS NPU, dual 2.5GbE and M.2 PCIe 3.0 x4. Check the selected eMMC and wireless configuration.

Hardware documentation · Product details

Sige3 · RK3568B2

RK3568B2 with a 2.5GbE port and a separate Gigabit Ethernet port. Consult the revision-specific manual for expansion and boot support.

Hardware documentation · Product details

Frequently asked questions

Can I add the speeds of two ports to claim routing throughput?

No. Measure traffic through the configured routing path.

Product information and support

Explore Sige7

Contact ArmSoM

Sources

Written by ArmSoM using the documentation below. Example designs are proposals, not measured customer installations.

Related reading